Pre-order with discount, delivery first week of May
Some of the spec of the plate carrier.
Frame and backing of the carrier is made from a single piece of 36 oz Hypalon. This translates into zero chance of shoulder straps coming unstitched if you have to put excessive load on the plate carrier (man down/ dragging a teammate of the X)
Backing is made from 3d spacer mesh
ITW quick mount buckles.
Vertical webbing for itw quick clips are Velcro covered, giving you a continuous area for front patching.
Cummerbund - 4 inch elastic with built in mag holder/storage, box stitched, triple stitched in high wear areas.
Cummerbund has 14 inch of adjustment, with Hypalon pull tabs.
Shoulder straps have 8 inch of adjustment, with 1 ¼ slots lasercut into them to allow for attachments as needed.
Plate pocket size will take 10x12 shooter's cut plates up to 1 inch thick.
Both front and back are fully covered in Velcro, so as to not limit your placement of I.D patches.
All textiles meet US mil spec, including rot resistant stitching.
As all textiles used are synthetic. This plate carrier will not retain any water, and has a very low IR signature.
100% made in Canada by people that understand that “good enough” is not acceptable.
Please contact us for more detailed information.